Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
PGTCGI
Before
After
Before
After
Before
AfterMr-Glass Roof Replacement & Installation in Miami Beach: What to Know First
Mr-Glass roof replacement and installation in Miami Beach typically runs $8,500 to $22,000 depending on roof size, underlayment condition, and whether you’re doing a full tear-off or a recover. Most jobs we handle take 3 to 6 working days once materials land. We’re an independent Mr-Glass service provider, which means we work on your roof without the inflated pricing or scheduling bottlenecks you sometimes get going straight through a manufacturer’s preferred network.
This page is for Miami Beach homeowners who already have Mr-Glass roofing products or are weighing Mr-Glass against other brands for a new install. If you need a straight answer on cost, timing, or whether your current Mr-Glass roof can be repaired instead of replaced, call (863) 656-0462 and you’ll get me or one of my crew on the line, not a call center.
Key Takeaways
- We install and replace Mr-Glass roof systems as an independent contractor, not a manufacturer rep.
- Free estimates with line-item pricing. No change orders unless you change the scope.
- Every Mr-Glass roof job is backed by our 36500-Day Done Right Promise.
- We also work with PGT, CGI, CWS, and ES Windows products, so we can match materials across your whole exterior.
How Mr-Glass Products Fail - and How We Fix Them
Mr-Glass makes a solid roof product, but twenty years of Miami Beach salt air, hurricane cycles, and UV exposure will find the weak points in any system. Here’s what we actually see on Mr-Glass roofs in this area:
- Flashing separation at parapet walls on the Mr-Glass Tile Series. Miami Beach homes with flat or low-slope roofs and parapet walls see the metal flashing pull away from the wall over time. The real cause is usually thermal expansion cycling combined with degraded sealant from constant salt exposure. We strip the old flashing, inspect the wall substrate, and install new counter-flashing with a marine-grade sealant rated for coastal conditions.
- Underlayment breakdown under Mr-Glass shingle systems. The shingles themselves often look fine, which is why so many owners miss this. What fails first is the synthetic underlayment, especially on older Mr-Glass installs where the original contractor used a cheaper felt product. When we do a replacement, we always pull back a section to check what’s underneath. If the underlayment is compromised, a full tear-off is the honest recommendation, not a patch job.
- Roof-to-wall transition leaks on Mr-Glass panel systems. On Mr-Glass’s standing seam and panel profiles, we frequently find leaks where the roof meets a stucco wall. The cause is almost always step flashing that was installed too shallow or sealed with a product that hardens and cracks in the Miami sun. Our fix involves opening the wall interface, installing proper step flashing with a minimum 4-inch overlap, and resealing with an elastomeric product that moves with the building.
- Clogged and overflowing internal drains on low-slope Mr-Glass roofs. Many Miami Beach Mr-Glass low-slope installations use internal drains instead of exterior gutters. When those drains clog with sand, palm debris, or roofing granules, water ponds and works its way into the system. We clear the drains, inspect the strainer baskets, and often recommend installing secondary overflow scuppers if the original design didn’t include them. This is a code requirement in Miami-Dade that some older Mr-Glass installs predate.
- Fastener back-out on Mr-Glass metal roof panels in high-wind zones. In beachfront and near-beach Miami Beach neighborhoods, we’ve seen Mr-Glass metal panels where the fasteners begin to back out after repeated hurricane-force wind loading. The neoprene washers degrade too. During a replacement, we upgrade to stainless fasteners with oversized washers and verify spacing against current Miami-Dade wind-load maps, which have changed since many of these roofs went in.
Our Mr-Glass Roof Replacement & Installation Process
If you’ve been burned before, here’s exactly how a Mr-Glass roof job goes with us:
- 1
You call (863) 656-0462. A real person answers, 24/7. You tell us about your Mr-Glass roof and what you’re seeing. We’ll ask a few questions and schedule a time that works for you.
- 2
We walk the property. Ed or a senior tech inspects the roof, checks the attic or underside where accessible, and takes photos. You get a straight explanation of what we found, in plain English.
- 3
You get a written line-item estimate. No lump-sum mystery number. We break out materials, labor, disposal, and permits. The price on that sheet is the price you pay unless you change the scope.
- 4
We decide on parts together. For Mr-Glass systems, we’ll recommend OEM panels, shingles, or tiles where it matters for warranty continuity. Where an aftermarket component performs identically and saves you real money, we’ll tell you that too. You make the call with full information.
- 5
Installation day. Background-checked, uniformed crew arrives on time. We protect your landscaping and walkways, do the tear-off or prep, and install. Permits are pulled and inspections scheduled as required.
- 6
Final walkthrough and cleanup. We inspect with you, run a water test where applicable, and make sure the site is cleaner than we found it. Then the clock starts on our 36500-Day Done Right Promise.
What Mr-Glass Roof Replacement & Installation Costs in Miami Beach
Here’s what we typically see for Mr-Glass work in Miami Beach as of this writing:
- Full tear-off and replacement with Mr-Glass asphalt shingles: $8,500 to $13,500 for a standard 1,500 to 2,200 square-foot single-family roof.
- Mr-Glass standing-seam metal roof replacement: $16,000 to $22,000 depending on seam profile, roof complexity, and whether we’re replacing the underlayment system.
- Mr-Glass tile roof replacement with new underlayment: $14,000 to $19,000. Tile salvage during tear-off can lower materials cost if the existing tile is still in good shape.
- Partial roof section replacement or recovery: $4,000 to $8,500 when damage is isolated to one slope or section.
What moves the price: roof pitch and accessibility, the condition of the decking underneath, whether the existing Mr-Glass materials can be salvaged or must be fully disposed of, and current permit fees in Miami Beach. Call (863) 656-0462 for an exact quote. Estimates are free, and we’ll hand you a number you can actually plan around.
Why Miami Beach Homeowners Call Winslow Windows & Doors for Mr-Glass Work
Ed Winslow’s name is on every job we do. That keeps us honest. We’ve been at this since 2011, headquartered right here in the area with a published address and license number. When you call about a Mr-Glass roof at 11 p.m. because a storm just rolled through, someone picks up. Not a voicemail. Not a call center in another state.
The 36500-Day Done Right Promise applies to every Mr-Glass roof replacement and installation we complete. If it’s not done right, we make it right. That’s a century of accountability no national chain is going to hand you. And because we also install PGT, CGI, CWS, and ES Windows exterior products, we’re the crew that can handle the whole envelope of your Miami Beach home without juggling multiple contractors. Ed grew up in Miami, trained at Miami Dade College’s Building Construction Technology program, and has spent decades watching what this climate does to poorly installed exteriors. That experience shows up in every roof we replace.
FAQs
No. Since we’re an independent contractor, your Mr-Glass material warranty remains with the manufacturer. What matters is that the installation meets their documented specs, which we follow on every job. We’ll flag anything in your current roof that was installed outside those specs so you understand exactly where you stand.
Most Mr-Glass roof replacements in Miami Beach take 3 to 6 working days once materials are delivered. Material lead time varies by product line, but we’ll give you a real schedule before you sign anything. Call (863) 656-0462 and we’ll check current availability for your specific Mr-Glass product.
In many cases, yes. Mr-Glass color and profile matching depends on the age of your roof and whether the original line is still manufactured. We’ll pull a sample from your existing roof and confirm the match before ordering. If an exact match isn’t available, we’ll tell you up front and walk you through the closest options with pricing for each.
Not unless we find something hidden that requires a scope change, like rotted decking that couldn’t be seen until the old roof came off. If that happens, we stop, show you photos, and give you a revised line-item number before any additional work proceeds. No surprises on the final invoice. That’s how we’ve operated since 2011.
Yes. Roof replacement in Miami Beach requires a permit, and we handle the entire process including scheduling inspections. We’ll make sure the job passes before we call it done. We also offer a free second opinion on any written estimate you’ve received from another contractor.
Written by Ed Winslow, Owner, Winslow Windows & Doors at Winslow Windows & Doors, serving Miami Beach and nearby areas.
Six Reasons Homeowners Choose Winslow Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.